Mitel SX-200 Practices page 672

Hotel/Motel Feature Package Description
System Contiguration
Hardware
2.3 Basic hardware is described in Table 2-6 and shown in Figure 2-l 6.
Table 2-8 Hotel/Motel Hardware
Hardware Description
SX-2tiO DIGITAL PABX This PABX can be any hardware configuration.
Wendant Console Provides telephony as well as access to Hotel/Motel features. A system
can support 11 attendant consoles, however, Hotel/Motel applications
usually use one console only. If more than one console is available on
the system, each operates independently. That is, two consoles could
change the same information for a room at the same time. In that case,
the console that left the room last would have its changes captured by
the system. If an attendant console and a front desk terminal are
configured on a system, the attendant console can access a room
already accessed by a front desk terminal and change the same
information at the same time. However, a front desk terminal cannot
access a room already accessed by a console, If the console leaves the
room last, its changes are captured.
The attendant console can be used in place of a WI&I terminal for
maintenance and/or CDE programming. Four lines of a CDE form can
be displayed at a time: three lines of information and the active line.
Guest Room
Telephones
Any type of industry-standard telephone can be configured on the
system. Industry-standard guest room telephones allow guests access
to certain Hotel/Motel features.The number is limited by the hardware
configuration of the SX-200 DIGITAL PABX.
Front Desk Terminal
The system can support up to four W70U terminals as front desk
terminals. Each terminal must interface to the PABX through a
MlTELll 00-series dataset. If more than one terminal is available on the
system, only one of them can make changes to the same guest room at
a time. If a front desk terminal attempts to access a guest room already
accessed by an attendant console, the terminal is blocked from access.
VT100 Terminal Used for maintenance and/or CDE programming. It displays full-screen
CDE forms facilitating data entry.The maintenance terminal can be
associated with a system printer to print alarm logs.
System Prlnter
Delivers hard copies of alarm logs, It can also be used to print
Hotel/Motel audits and single line reports. Separate printers can be
used.
SUPERSET +JDN
SUPERSET 4201430
Telephones
Since these telephones can display room status information, they can
be used as supervisory sets by hotel staff. They can also be used as
guest room telephones. Programming can allow guests single-key
access to designate dfeatures.
SUPERSET 3i3DN
SUPERSET 4011410
Telephones
Non-display telephones that can be programmed to allow guests
sing&key access to designated features.
602 2-22
Revision 0 9 109-096-602-NA
Issue 1