Mitel SX-200 Practices page 129

Features
The set does not actually warble; instead an alerting tone is heard
through the speaker. Call end tone is heard when the call is com-
pleted.
If Auto-Answer is used with the headset feature then the tones are
heard in the headset and not through the speaker.
The feature prevents calls directed at the prime line of the SUPERSET
telephone from ringing other appearances of the prime line because
the call is automatically answered. If the call is not automatically an-
swered (the prime appearance or the SUPERSETtelephone is busy)
then the other appearances ring if possible. ;
The feature only operates for calls directed at the prime line of a
SUPERSETtelephone.
The feature prevents any other line appearances on the set from caus-
ing the set to ring. Instead, the new call ring is used to notify the set
user of new calls on other lines.
In some cases where the SUPERSETtelephone would be put sus-
pended at the end of a call, a set with Auto-Answer enabled goes idle
immediately.
Auto-Answer is ignored when callbacks, recalls and hold timeout re-
calls ring the SUPERSETtelephone.
In ACD, agents can be forced into Auto-Answer mode upon login; re-
fer to Practice 9109-096-62&NA, ACD TELEMARKETER@
Application Package.
Programming
Enable COS Option 600 SUPERSET (Auto-Answer) in the telephone's
cos.
To enable Auto Answer for a SUPERSET telephone that is equipped
with a headset, enable COS Option 600 SUPERSET(Auto-Answer) and
COS Option 612 (SUPERSET Telephone - Headset Operation) in the
SUPERSET telephone's COS.
To provide access code activation of Auto-Answer, program a Feature 02
(Auto-Answer) access code in CDE Form 02 (Feature Access Codes).
To provide feature key activation of Auto-Answer at SUPERSET 3DN,
SUPERSET DN, SUPERSET410, SUPERSET420, or SUPERSET
telephones, program an AUTO-ANSWER feature key. (See Feature Keys.)
Operation
Operation varies depending on the type of SUPERSETtelephone as de-
scribed below.
SUPERSET Telephones:
To activate Auto-Answer:
l
Dial the Auto-Answer feature access code, followed by the digit "1".
9109-096-l 05-NA
Issue 1 Revision 0
105 2-57