Application Platform Package - Mitel SX-200 Practices

Features Description
Application Platform Package
Description
The Application Platform Package (or MITEL Application Interface - MAI)
allows Mite1 computer-based applications to have access to SX-ZOO
DIGITAL features. The MAI is used in conjunction with an external host
computer connected via an RS-232 link to a DATASET 2100 device. The
DATASET device is connected to a Digital Line Card port on the PABX via
" a single twisted pair.
The appropriate Decryption Module must have been installed on the Main
Control card in order for this feature to operate.
Conditions
The protocol is based on the following communications standards: CCITT
X.409, CCllT X.41 0 and LAPB (CCITT X.25).
This feature is available in Generic 1004 and Generic 1005 only.
Only one MAI port can be programmed on the system.
Programming
The following steps are required:
l
Program a Digital Line card into Form 01 (System Configuration).
l
Enable System Option 19 (Mite1 Application Package) in Form 04
(System Options and Timers).
l
A data circuit descriptor must be set up for the MAI port. This is done
in Form 11 (Data Circuit Descriptors). Only 3 fields require modifica-
tion:
- DATASET
2100: Operating Mode SYNCHRONOUS
- SYNC: Rate Adaption Scheme X.31
- SYNC: Clock Source
SYSTEM
- Ensure the Session
Inactivity Timer in the corresponding Data Cir-
cuit Descriptor is set to 0
l
The descriptor is then assigned to the circuit in Form 12 (Data Assign-
ment) in the CDN field.
9 Within Form 34 (Directed I/O) enter the extension number of the
DATASET, press the MAI softkey and the AUTOPRINT softkey.
Operation
Operation is dependent upon the application.
105 2-14
Revision 0 9109-096-l 05-NA Issue 1