Mitel SX-200 Practices page 136

Features Descrbtion
If COS Option 613 (Display ANI Information Only) is enabled, the
SUPERSETtelephone displays the ANI digits during both the unanswered
and answered states. In this case, if ANI digits are not provided, the display
shows the normal trunk information.
You can program the system to record ANI and DNIS digits in the SMDR
reports. The digits are recorded at the end of the trunk SMDR record. Both
ANI and DNIS numbers are recorded up to a maximum of IO digits in length.
By default, ANI and DNIS numbers are not recorded in SMDR reports.
This feature is available in Generic 1005 systems only.
Conditions
The following conditions apply to this feature:
l
Only non-DISA trunks that are programmed with a Tl E&M,
or Ti DID/TIE trunk circuit descriptor can receive ANI and DNIS digits.
l
Incoming trunks must use DTMF signalling, and have a Wink Timer.
l
Only MCI and US Sprint standards are supported.
l
If US Sprint standard is used, calls cannot be routed to extensions that
have an * in their access number.
l
The PABX waits a maximum of 200 ms for each ANI/DNIS digit. If it
doesn't receive a digit within the 200 ms timeout period, the PABX
routes the call through to the extension.
l
The PABX uses the DNIS digits that are collected for an incoming call
to route the trunk call through the system.
l
The ANI and DNIS digit displays take priority over Analog Networking
digits, trunk group names, trunk names and trunk numbers.
l
If the PABX doesn't receive any ANI or DNIS digits for a call, then the
console or set display shows the trunk information of the call instead.
l
ANI and DNIS digit displays follow standard Call Forwarding rules
(See Call Forwarding).
l
On SUPERSETConsoles, Tenant Names and Calling Line Identifica-
tion displays take priority over ANIS digits, and the following displays
take priority over DNIS digits:
- Intercept reasoning (FROM xxxx DND)
- Forwarding information (FWD FROM xx@.
Programming
Enable COS Option 811 (ANVDNIS Trunk) and disable COS Option 801
(Incoming Trunk Call Rotary) for the trunk in Form 03.
In Form 13, assign the ANIS/DNIS trunk with one of the following Trunk
Circuit Descriptors:
l
Tl E&M
l
Tl DlDnlE
105 2-64
Revision 0 9109-096-l 05-NA
Issue 1