Mitel SX-200 Practices page 175

Features
Consoles and extensions can transfer a party on consultation hold as
soon as forwarding to an external number starts, at any point in dialing
the external number.
The reference is to the stored Speedcall key number or the personal
or system Abbreviated Dial number. If this stored number is changed,
then the forwarding destination changes also.
Programming Enable COS Option 208 (Call Forwarding - External) in the extension' s
cos.
Enable COS Option 245 (Abbreviated Dialing Access) for the extension to
allow forwarding to system Abbreviated Dial numbers or to Key System
personal speedcalls.
Disable COS Option 200 (Account Code, Forced - External Calls) in the
extension' s COS.
Enable System Option 21 (Incoming to Outgoing Call Forward) to allow
trunks to be externally call forwarded.
Ensure Feature Access Code 03 (Call Forwarding -All Calls) has a feature
access code programmed.
For feature key activation of call forwarding on a SUPERSET 3 DN,
SUPERSET 410,
or
SUPERSET 420
telephone, program a CALL
FORWARD feature key. (See Feature Keys.)
Operation Operation varies depending upon the device type as described below.
Industry-standard and SUPERSET Telephones:
To set up Call Fowarding - External at an Extension:
.
.
a
.
.
.
Replace the handset - Call Forwarding - External is now active.
Lift the handset - dial tone is heard.
Dial the Call Forward - All Calls access code.
Dial the condition code for the desired type of Forwarding.
Dial the Abbreviated Dial Index Number, which contains the external
telephone number to which calls are to be forwarded. Dial tone is re-
turned if the above codes are valid; reorder tone is returned if the
codes are invalid.
To cancel Call Forwarding - External at an Extension:
l
Lift the handset - dial tone is returned.
l
Dial the Call Forward - All Calls access code (assuming Split Call For-
warding is disabled).
0 Replace the handset - Call Forwarding - External is now inactive.
9109-096-l 05-NA
Issue 1 Revision 0
105 2-103