Mitel SX-200 Practices page 244

Features Description
Conditions
The following conditions apply to this feature:
This feature is available only on SUPERSET 4, SUPERSET 4 DN,
SUPERSET 410, SUPERSET 420, and SUPERSET 430 telephones.
In a data call, both modems must operate at the same baud rate; one
modem must be in Originate mode, the other in Answer mode.
The only effect of AML on voice calls is that the SWAP (Trade Calls)
softkey appears on calls to a station which has an Associated Modem
Line or on trunk calls.
When two telephones assigned the same modem port converse, the
SWAP (Trade Calls) softkey does not appear; data communication be-
tween these telephones is not possible.
If the set user presses the SWAP (Trade Calls) softkey when the data
port is already in use, the message DATA BUSY appears on the dis-
play. Hang up or press the CANCEL softkey.
An AML data device may be associated with more than one telephone
(only one can use it at a time); however, a telephone may be asso-
ciated with only one AML data device.
Programming
Enable COS Option 607 (SUPERSETTelephone - Associated Modem
Line) for the telephone.
Enter the associated modem ONS port extension number in the
ASSOC field
of the associated telephone entry in CDE Form 09 (Station /SUPERSET
Telephones).
Enter the extension number of the associated telephone in the ASSOC field
of the modem port entry in CDE Form 09 (StationlSUPERSETTelephones),
if the terminal is to be able to dial a call on behalf of the associated telephone.
Operation
To make a Data Call from the SUPERSETtelephone:
.
.
Dial the number of the destination modem; when the destination mo-
dem answers, it returns a modem answer tone.
Press the SWAP (Trade Calls) softkey.
Note: If the modem line is already connected to a call, orthe modem is attempting to
make a data connection, the message " D ATA BUSY' appears. The CANCEL
softkey is then the only key available.
l
Put the modem on-line; the data call is now established.
l
Press the HANG UP (or New Call) softkey.
The SUPERSETtelephone is now available for voice calls. In this way, it is
possible to have simultaneous voice and data calls. The data call terminates
when the modem goes on-hook.
105 2-172
Revision 0
9109-096-l 05-NA
Issue 1