Xerox WorkCentre 5687 Series Service Manual page 1205

REP 10.9 Shaft Actuator
Parts List on PL 10.11
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the inverter assembly, REP 10.2.
2. Remove the inverter nip solenoid, REP 10.5.
3. Remove the shaft actuator, Figure 1.
2
Remove the shaft actuator
Figure 1 Shaft actuator
Replacement
Replacement is the reverse of the removal procedure. Refer to GP 6 before refitting the
screws.
WorkCentre 5687 Family
NOTE: Check that both springs are positioned correctly, Figure 2.
1
Unclip both springs
August 2007
4-185
Spring position
Figure 2 Location of the spring
Repairs/Adjustments
REP 10.9