Xerox WorkCentre 5687 Series Service Manual page 1523

8. Figure 3. At the rear of the HVF, Remove the circlip, bush, pulley and the rear screws from
the magnet bracket.
5
Remove 2 screws
REAR VIEW
Figure 3 Rear component removal.
WorkCentre 5687 Family
1
Remove the circlip
2
Slide the pulley and
the bush along the
shaft
3
Slip the belt off of
the pulley
4
Remove the pulley and
the bush
August 2007
4-503
9. Figure 4. Remove the top exit feed roll.
1
Remove the
magnet bracket
Figure 4 Top exit feed roll removal.
Replacement
The replacement procedure is the reverse of the removal procedure.
2
Remove the top
exit feed roll
Repairs/Adjustments
REP 11.47-171