Xerox WorkCentre 5687 Series Service Manual page 1086

REP 5.9 Length Detect Sensors
Parts List on PL 5.35
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the input tray assembly, REP 5.4.
CAUTION
Disconnect the ground harness from the static eliminator before the input tray assembly lower
cover is removed, refer to Figure 1.
2. Turn the input tray assembly upside down. Remove the relevant cover:
• (32-38 ppm) Input tray assembly lower cover, PL 5.35 Item 21.
• (45-87 ppm) Lower cover (right), PL 5.35 Item 9 and Lower cover (left), PL 5.35 Item
20
3. Remove the length detect sensors, Figure 1.
1
Remove the ground harness
and bracket.
Length sensor 2.
Length sensor 1.
Figure 1 Length detect sensors
Repairs/Adjustments
REP 5.9
Ground harness.
See CAUTION.
2
Disconnect the correct PJ. Remove
the correct sensor.
August 2007
4-66
Replacement
CAUTION
Be careful when the self tapping screw is installed into a plastic component, refer to GP 6.
The replacement is the reverse of the removal procedure.
WorkCentre 5687 Family