Xerox WorkCentre 5687 Series Service Manual page 1475

REP 11.15-171 HVF Rear Tamper Assembly
Parts List on PL 11.140
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the rear cover REP 11.1-171.
2. Remove the right side-cover REP 11.5-171.
3. Remove the ejector assembly REP 11.6-171.
4. Disconnect 2 PJs and remove the rear tamper assembly, Figure 1.
WorkCentre 5687 Family
2
1
Remove 2 screws and move the
Remove the pressing
assembly to the right to disen-
plate drive motor
gage the 2 locating pins on the
left side.
Figure 1 Rear Tamper Assembly
Replacement
Check that the Ejector cable harnesses are routed below rear tamper assembly and do not
obstruct any moving parts.
Reverse the removal procedures to reinstall the rear tamper assembly.
Turn the offset drive gear to position the offset carriage so that the rear tamper assembly can
be positioned on the locating pins.
August 2007
4-455
Disconnect 2 PJs.
3
Move the assembly forward.
Turn the offset motor gear to
move the offset carriage to the
rear.
CAUTION
Repairs/Adjustments
REP 11.15-171