Xerox WorkCentre 5687 Series Service Manual page 1650

ADJ 7.3 Tray 5 Module to Machine Alignment
Parts List on PL 7.64
Purpose
To correctly align the tray 5 module to achieve correct top edge registration and reliable trans-
fer of paper from the tray 5 module to the machine.
Adjustment
The adjustment must be performed in the following order:
1. Figure 1, turn the hand wheel above the front castor at the left of the tray 5 module to set
tray 5 level with the left hand door. The measurement between the left hand door and tray
5 should be equal at the front and the rear. This is the nominal position for tray 5 and the
image registration and hole punching should need little or no correction.
NOTE: Before each adjustment or measurement, un-dock and re-dock the module to
reset the tray 5 position.
2. Make prints to check for image registration and correct hole punching. If necessary, con-
tinue to step 3.
3. Figure 1, turn the wheel as necessary. The '+' direction moves the paper towards the front
of the machine. The '-' direction moves the paper towards the rear of the machine.
4. Check the registration, refer to dC604 Registration Setup Procedure.
Repairs/Adjustments
ADJ 7.3
Ensure edges are
parallel
-
Figure 1 Machine to tray 5 alignment
August 2007
4-630
Turn the wheel at the front
to obtain the alignment.
+
WorkCentre 5687 Family