Xerox WorkCentre 5687 Series Service Manual page 1243

1
Move the output
cover to the right
Figure 4 Paddle wheel shaft removal
Replacement
1. Install the paddle wheel shaft, ensure that the pin on the rear of the safety gate switch
cam, refer to Figure 3, locates in the safety gate. Install the front E-clip.
2. Install the output cover, refer to Figure 4, ensuring that the safety gate is aligned with the
slots in the output cover.
3. Install the rear bearing and E-clip.
4. Install the switch bracket, 1 screw, connect the harness, refer to Figure 3.
WorkCentre 5687 Family
2
Slide shaft assembly
to the rear
3
Remove the
shaft assembly
August 2007
4-223
5. Install the gear assembly, refer to Figure 2, ensuring that it locates onto the large "D" flat.
6. Install the flag and E-clip, refer to Figure 2, ensuring that the flag locates on the small "D"
flat.
7. Figure 5, ensure the paddles and flag are correctly aligned, install the motor assembly,
refer to Figure 1.
Figure 5 Paddle alignment
8. Test the operation of the paddle roll, enter dC330, output code 11-025. When the code is
cancelled the paddles must stop with both rubber blades inside of the output cover. If nec-
essary, check that the gear assembly and flag are correctly located on the "D" flats.
1
Align paddles with the output cover
2
Ensure the
encoder flag is
within the sensor
Repairs/Adjustments
REP 11.12-110