Xerox WorkCentre 5687 Series Service Manual page 1267

REP 11.14-120 Docking Latch Assembly and Docking
Interlock Switch
Parts List on PL 11.102.
Removal
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the 1K LCSS, REP 11.11-120.
2. Figure 1, prepare to remove the docking latch assembly.
1
Disconnect PJ6.
Figure 1 Preparation
3. Figure 2, remove the docking latch assembly.
WorkCentre 5687 Family
4
Remove 2 screws
2
Release 2 harness
retainers.
4. Remove the sensor cover, PL 11.102 Item 1.
5. Release the docking interlock switch from the sensor cover.
3
Replacement
Pull the harness
Reverse the removal procedure to replace the docking latch assembly.
through the flanged
hole.
Ensure that the harness is put through the flanged hole, refer to Figure 1.
August 2007
4-247
3
Remove the latch
assembly
1
Release the harness
retainer
2
Remove 2 screws
Figure 2 Latch assembly removal
CAUTION
Repairs/Adjustments
REP 11.14-120