Xerox WorkCentre 5687 Series Service Manual page 1484

REP 11.21-171 BM Backstop Assembly
Parts List on PL 11.163
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the booklet maker, REP 11.61-171.
2. Rotate the crease roll handle (6c), fully counter clockwise.
3. Remove the crease roll handle (6c), PL 11.161 Item 5.
4. Remove the crease blade knob (6d), PL 11.161 Item 4.
5. Remove the BM front cover, PL 11.161 Item 3.
CAUTION
The BM harnesses and the backstop assembly harnesses are connected with a catch. Ensure
the catch is released when disconnecting the solenoid harnesses.
Repairs/Adjustments
REP 11.21-171
6. Remove the two harness clamps, Figure 1.
Figure 1 Remove the two harness clamps
August 2007
4-464
Lay down the BM assembly to access the
backstop assembly.
1
Use a flat blade screwdriver
to push out the harness
clamp.
2
Use a flat blade screwdriver
to push out the harness
clamp.
WorkCentre 5687 Family