Xerox WorkCentre 5687 Series Service Manual page 1477

1
Remove the KL-clip and
the bearing.
Figure 2 BM flapper assembly removal
4. Figure 3, remove the BM flapper.
2
3
Remove the KL-clip, then
Remove the KL-clip, then
the bearing.
the bearing.
Figure 3 BM flapper removal
Replacement
The replacement is the reverse of the removal procedure.
WorkCentre 5687 Family
REP 11.17-171 BM PWB
Parts List on PL 11.166
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the top cover, then the rear cover, REP 11.1-171.
2
Remove the BM flapper
assembly.
1
Remove the E-
clip, pin, then the
pulley.
August 2007
4-457
WARNING
WARNING
Repairs/Adjustments
REP 11.16-171, REP 11.17-171