REP 4.4 Photoreceptor Drive Gear
Parts List on (32-55 ppm) PL 4.15, (65-87 ppm) PL 4.10.
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1.
Remove rear cover, PL 8.10 Item 1.
CAUTION
When the drive gear is removed from the shaft, the dowel pin may drop onto the IOT PWB or
LVPS.
2.
Remove the photoreceptor drive gear, Figure 1.
1
2
Remove three short
Remove the screw
screws and the fly
and collar
wheel
Figure 1 Photoreceptor drive gear
WorkCentre 5687 Family
Replacement
Replacement is the reverse of the removal procedure. Refer to GP 6 before refitting the
screws.
NOTE: Turn the drive shaft, so that the dowel pin is horizontal then locate the drive gear onto
the drive shaft.
3
Remove the drive gear
and the dowel pin
August 2007
4-53
Repairs/Adjustments
REP 4.4