Xerox WorkCentre 5687 Series Service Manual page 1160

Replacement
1. The replacement is the reverse of the removal procedure. Refer to GP 6 before refitting
the screws.
2. Make sure that the spring on the paper feed assembly is in the correct position, Figure 3.
Figure 3 Feed assembly spring
3. Make sure that the spring is position on top of the nip roll shaft when the bracket housing
is installed, Figure 4.
Spring position
Figure 4 Nip roll spring
4. Make sure that the spring is positioned on top of the chute upper insert, Figure 5.
Repairs/Adjustments
REP 8.25
Place the spring under the
post
Position Spring on the top of the chute
5. Check that the correct screw is used to attach the bracket housing.
6. Check that the harness routing is correct, Figure 1.
August 2007
4-140
Figure 5 Upper insert chute spring
WorkCentre 5687 Family