Table of Contents
Advertisement
HCSS and HCSS BM CC Entrance Baffle Fingers
1.
Remove the compiler carriage assembly, REP 11.2-130 or REP 11.2-170.
2.
Figure 20, Use plastislip grease, PL 26.10 Item 8, to lubricate the entrance baffle fingers.
Figure 20 Baffle fingers lubrication
3.
Re-install the compiler carriage assembly, REP 11.2-130 or REP 11.2-170.
Repairs/Adjustments
ADJ 4.1
1
Bend a finger away from the
shaft, apply grease to the fin-
ger adjacent to the shaft
2
Repeat the grease applica-
tion to the remaining 5 baffle
fingers
HCSS and HCSS BM CC Entrance Baffle Nip Rollers
Parts list on: PL 11.48 (HCSS), PL 11.74 (HCSS BM)
1.
Remove the CC nip shaft components, REP 11.40-130 or REP 11.54-170.
2.
Use plastislip grease, PL 26.10 Item 8, to lubricate the area of the shaft where the nip roll-
ers are located.
3.
Re-install the CC nip shaft components, REP 11.40-130 or REP 11.54-170.
HCSSBM CC Paddle Roll Motor Worm and Gear
Parts list on: PL 11.47 (HCSS), PL 11.73 (HCSS BM)
1.
Remove the HCSS top cover, REP 11.1-130 or the HCSSBM top cover, REP 11.1-170.
2.
Enter dC330 code 11-021 move ejector out, to lift the eject housing and expose the worm
and gear.
3.
Use plastislip grease, PL 26.10 Item 8, to lubricate the paddle roll motor worm and gear. If
necessary, use a small flat blade screwdriver to apply the grease.
4.
Re-install the HCSS top cover, REP 11.1-130 or the HCSS BM top cover, REP 11.1-170.
HCSSBM Area 5a / 6a and 5b Nip Rollers
Parts list on: PL 11.36 (HCSS), PL 11.66 (HCSS BM).
1.
Remove the top cover and upper left cover, REP 11.1-130 or REP 11.1-170.
2.
Figure 21, use plastislip grease, PL 26.10 Item 8, to lubricate the area 5a/6a and 5b nip
rollers.
August 2007
4-614
WorkCentre 5687 Family
Hide quick links:
Advertisement
Chapters
Table of Contents
