Xerox WorkCentre 5687 Series Service Manual page 1693

5. Figure 3, close the stapler.
4
Tighten the two screws alternately a little at a time, while
holding the free screw with a finger. Ensure that the anvil
does not move as the screws are tightened
WorkCentre 5687 Family
Figure 3 Closing the stapler
August 2007
4-673
2
Continue to rotate the
stapler gear so that the
two protrusions on the
tool engage with the
depressions in the
anvil. Move the anvil if
necessary using the
two clamp screws
Anvil
Clamp plate
Spacer
1
Rotate the stapler gear counterclockwise
to begin closing the stapler
3
Continue to rotate the stapler gear
until the anvil is tightly clamped by
the alignment tool and the stapler
will close no further
Repairs/Adjustments
ADJ 11.3-171