Xerox WorkCentre 5687 Series Service Manual page 1289

Figure 7 Elevator belt removal
12. Figure 8, remove the front elevator belt.
WorkCentre 5687 Family
1
Remove the belt tensioner
spring
2
Slide the belt off the pulley
and remove through the hole
in the frame
Replacement
1.
2.
August 2007
4-269
4
Remove the belt
from the top pulley.
3
Remove the belt
tensioner spring
Figure 8 Releasing the belt
Reverse the removal procedure to replace the compiler carriage elevator belts. Ensure
the small belt is returned to its original position on the pulley.
Tension the compiler carriage elevator belts, refer to REP 11.8-130.
2
Lift the shaft slightly and slide the belt
off the pulley and free from the frame
1
Remove 2 screws
Repairs/Adjustments
REP 11.7-130