Xerox WorkCentre 5687 Series Service Manual page 1615

Replacement
CAUTION
Take care when replacing the scan carriage ribbon cable. The scan carriage ribbon cable is
easily damaged.
1. The replacement procedure is the reverse of the removal procedure.
2. Perform ADJ 14.1B Optics Cleaning.
WorkCentre 5687 Family
REP 14.14B Document Size Sensor 1 and Document Size
Sensor 2 (65-87 ppm)
Parts List on PL 14.16
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the document glass, the CVT glass, and the CVT ramp assembly, REP 14.3B.
2. Figure 1. Remove document size sensor 1 (Q14-315).
NOTE: The removal of document size sensor 1 (Q14-315) is shown. The removal of doc-
ument size sensor 2 (Q14-320) is identical.
3
Remove the document size sensor
Figure 1 Remove size sensor 1 (Q14-315)
Replacement
1. The replacement procedure is the reverse of the removal procedure.
2. Perform ADJ 14.1B Optics Cleaning.
August 2007
4-595
WARNING
WARNING
1
2
Disconnect the
Remove 1 screw
harness
Repairs/Adjustments
REP 14.13B, REP 14.14B