Table of Contents
Advertisement
d.
Select dC131 NVM Read/Write.
e.
Select 12Finisher/DFA.
f.
Select 12-003 BookMkrCompileOff-set.
g.
Select Read/Write and enter the new value to correct the error found during the
check. Increasing the value will raise the sheet. Decreasing the value will lower the
sheet. One step = 0.1137mm.
h.
Select Save, select OK, select Close, select Exit.
2.
Repeat the Check to ensure the compiling position is correctly set.
3.
When the compiling position is correct, switch the machine off then on, GP 14.
8.5 X 11 Inch Procedure
Check
1.
Open the HCSS BM front door and insert an interlock cheater into the front door interlock
switch.
2.
Fully pull out the BM module and release the jam clearance handle PL 11.80 Item 8, fully
open the paper guide PL 11.80 Item 7.
3.
Do the following
a.
Enter dC131.
b.
Select Diagnostic Routines.
c.
Select Copier Routines.
d.
Select dC131 NVM Read/Write.
e.
Select 12Finisher/DFA.
f.
Select 12-003 BookMkrCompileOff-set.
g.
Select Read/Write and increase the original value by 80.
h.
Select Save, select OK, select Close, select Exit.
4.
Enter dC330 code 11-065 BM Backstop Motor, select Start, allow the backstop to raise to
the receive position (where it will pause), select Stop.
5.
Insert a single sheet of 8.5 X 11 inch paper short edge downward into the booklet maker
compiling area, so that it rests on the backstop and is approximately central front to back.
Tuck the top of the sheet behind the BM entry roll, PL 11.80 Item 15.
6.
If the BM right hand cover does not have a viewing hole, remove the BM right hand cover,
REP 11.56-170.
7.
Figure 2, check the alignment of the sheet against the scale.
WorkCentre 5687 Family
Top of sheet must align
with the bottom mark
on the B scale
Figure 2 Top edge alignment
8.
If the sheet is correctly aligned, do the following:
a.
Enter dC131.
b.
Select Diagnostic Routines.
c.
Select Copier Routines.
d.
Select dC131 NVM Read/Write.
e.
Select 12Finisher/DFA.
f.
Select 12-003 BookMkrCompileOff-set.
August 2007
4-663
Repairs/Adjustments
ADJ 11.6-170
Hide quick links:
Advertisement
Chapters
Table of Contents
