Xerox WorkCentre 5687 Series Service Manual page 1343

REP 11.2-170 Compiler Carriage Assembly
Parts List on PL 11.68
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the top cover, rear cover, front door and front cover, REP 11.1-170.
2. Remove bin 1, REP 11.5-170.
3. Figure 1, disconnect the harnesses.
WorkCentre 5687 Family
1
Release the harnesses
between the HCSS
PWB and carriage
PWB from the bridge
4
Disconnect the
ground wire
Figure 1 Disconnect the carriage PWB
4. Figure 2, move the stapler assembly inboard by about 75 mm (3 inches), by turning the
stapler traverse screw with a 5.5 mm nut driver.
August 2007
4-323
2
Cut 2 tie-wraps
3
Disconnect PJ401, PJ412,
PJ411 and PJ410 from the
carriage PWB
Repairs/Adjustments
REP 11.2-170