Xerox WorkCentre 5687 Series Service Manual page 1573

REP 11.90-171 Bottom Tray and Paper Sensors
Parts List on PL 11.175
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Undock the PPI, REP 11.82-171, and release the front and rear pivot tabs then lift the bot-
tom tray. Control the movement of the bottom tray springs.
2. Remove the circlip and bearing and remove the tray pivot shaft. Rotate the tray to access
the sensor bracket, Figure 1.
Pivot Shaft
Paper Present Sensor Bottom Tray
Figure 1 Bottom Tray and Sensors
3. Remove the sensor bracket and disconnect the PJs. Unclip the paper present sensor and
the paper width sensors from the bracket,
WorkCentre 5687 Family
Replacement
Reverse the removal procedure to replace the bottom tray and paper sensors.
Check that the loading levers are at the same angle and that the tray pivot shaft passes below
the front and rear loading levers. Check that the bottom tray is supported horizontally in the
frame.
Make sure that the bottom tray springs are correctly aligned before engaging the front and rear
pivot tabs.
Sensor Bracket
Paper Width
Sensors
Pivot Tab
August 2007
4-553
Repairs/Adjustments
REP 11.90-171