Xerox WorkCentre 5687 Series Service Manual page 1033

2. Figure 3. Insert a male or female terminal into the appropriate position of the crimp tool
and close the tool just enough to hold the terminal.
Figure 3 Crimping the terminal.
3. Insert the wire fully into the terminal so that the stripped portion of the wire is within the
inner grip of the terminal. Close the crimp tool fully to make the crimp.
WorkCentre 5687 Family
4. Figure 4. Insert the crimped terminal into the appropriate position of the crimp tool and
close the crimp tool, to fasten the insulation of the wire in the outer grip of the terminal.
Figure 4 Crimping the insulation grip.
August 2007
4-13
Repairs/Adjustments
REP 1.3