Xerox WorkCentre 5687 Series Service Manual page 1483

REP 11.20-171 BM Backstop Motor Assembly
Parts List on PL 11.163
Purpose
This procedure is used to repair the following components:
• Ground wire, PL 11.163 Item 1.
• Motor damper, PL 11.163 Item 3.
• BM backstop motor, PL 11.163 Item 4.
• BM backstop drive belt, PL 11.163 Item 11.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the HVF BM front door and fully pull out the BM module.
WorkCentre 5687 Family
2. Figure 1, remove the BM backstop motor.
6
Remove 2 screws to release the motor
from the bracket, remove 2 screws to
remove the motor and ground wire from
the damper
5
Remove the belt
4
Free the motor pulley from the belt
and lift out the motor assembly
Figure 1 Motor removal
Replacement
Reverse the removal procedure to replace the BM backstop motor.
NOTE: Allow the spring to tension the drive belt while the screws are still loose, then tighten
the 4 screws.
August 2007
4-463
1
Remove
allen key
and spring
2
Remove
4 screws
3
Disconnect the
motor harness
Repairs/Adjustments
REP 11.20-171