Xerox WorkCentre 5687 Series Service Manual page 1507

REP 11.35-171 Diverter Exit Gate
Parts List on PL 11.153
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the HVF front door, REP 11.1-171.
2. Remove the HVF top cover, REP 11.1-171.
3. Remove the HVF front cover, REP 11.1-171.
4. Remove the HVF rear cover, REP 11.1-171.
5. Figure 1. At the rear of the HVF, remove the solenoid arm, the K-L clip and the bush from
the diverter shaft.
3
Remove the bush
2
Remove the K-L clip
REAR VIEW
Figure 1 Removal preparation
WorkCentre 5687 Family
1
Pull the solenoid arm
from the shaft
August 2007
6. Figure 2. Remove the diverter exit gate.
Diverter
1
Open Guide 5c
Figure 2 Diverter removal
Replacement
After replacement, check the K-L clip is in the correct groove, and the bush cannot be pulled
from the frame.
The replacement procedure is the reverse of the removal procedure.
4-487
3
Remove the
diverter
2
Remove the
pivot screw
CAUTION
Repairs/Adjustments
REP 11.35-171