Xerox WorkCentre 5687 Series Service Manual page 1602

3
Remove the document glass
with the CVT ramp assembly
2
Loosen 6 screws and rotate 6 glass clamps away
from the document glass
Figure 1 CVT glass and document glass assembly
Replacement
1. The replacement procedure is the reverse of the removal procedure.
2. Ensure that the white AGC strips on the document glass and the CVT glass are at the
front and underside of the glass.
3. Perform ADJ 14.1B Optics Cleaning as necessary.
Repairs/Adjustments
REP 14.3B, REP 14.4B
REP 14.4B Scan Carriage Home Sensor (65-87 ppm)
Parts List on PL 14.15.
1
Removal
Remove 2 screws
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the scanner top cover, REP 14.2B.
Do not remove the document glass.
Do not loosen the two screws securing the setting plate, shown in Figure 1.
2. Figure 1, remove the scan carriage home sensor.
4
Remove the
sensor (1 screw)
August 2007
4-582
WARNING
WARNING
CAUTION
3
Disconnect the sensor
1
2
Remove the
Pull forward the sensor plate
screw
Figure 1 Scan carriage home sensor
Do not loosen
WorkCentre 5687 Family