Hvf Punch Unit Paper Edge Detect Rap - Xerox WorkCentre 5687 Series Service Manual

11-380-171 HVF Punch Unit Paper Edge Detect RAP

11-380-171 The punch unit failed to detect the edge of the paper.
Initial Actions
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Check that the paper path through the punch is clear, Figure 1. Check the punch module is
seated at the rear or the machine.
Procedure
Go to Flag 1. Check the wiring and repair as necessary, REP 1.2. Check the punch paper sen-
sor, Figure 1. Refer to:
• GP 11 How to Check a Sensor.
• P/J501 HVF control PWB.
• 11A-171 HVF Power Distribution RAP.
Install new components as necessary:
• Punch paper sensor, PL 11.153.
• HVF control PWB, PL 11.157 Item 2.
Enter dC330, code 11-000, entry feed motor 1, to check that the motor runs. The motor runs.
Y N
Go to Flag 2. Check the wiring and repair as necessary, REP 1.2. Check entry feed motor
1, MOT11-000. Refer to:
• GP 10 How to Check a Motor.
• P/J102 HVF control PWB
• 11A-171 HVF Power Distribution RAP.
Install new components as necessary:
• Entry Feed motor, MOT11-000, PL 11.150.
• HVF control PWB, PL 11.157 Item 2.
Perform SCP 6 Final Actions.
Status Indicator RAPs
11-380-171
Punch Paper sensor
Figure 1 Component location
August 2007
2-608
Entry Feed motor 1,
MOT11-000
REAR VIEW
WorkCentre 5687 Family