Xerox WorkCentre 5687 Series Service Manual page 724

If the top and bottom edge alignment does not conform to the specification in Table 2, check
the operation of the BM tampers, refer to the 11-066-170, 11-384-170 HCSS BM Tamper Fail-
ure RAP. If the tampers are operating correctly, go to ADJ 11.5-170 Booklet Tamping and check
the tampers are correctly adjusted.
If the booklet skew does not conform to the specification in Table 4. Perform the following:
• Check the operation of the BM stack hold solenoids, refer to 11-065-170, 11-383-170
HCSS Booklet Back Stop failure RAP.
• If the stack hold solenoids are operating correctly, check for contamination or debris in the
compiling area of the BM that could cause the mis-alignment.
• Perform ADJ 11.4-170 Crease Blade Position.
Open Side Edge Alignment
Figure 2, open out the booklet at the centre page and press it onto a flat surface. Measure the
mis-alignment of the open side edges of the booklet.
Status Indicator RAPs
11F-170
Measure the total scatter
Figure 2 Open side edge alignment
Table 3 Open side edge alignment
Paper weight
80gsm (20lb)
All other BM approved weights in GP 20
If the open side edge alignment does not conform to the specification in Table 3, check the
operation of the BM stack hold solenoids, refer to the 11-065-170, 11-383-170 HCSS Booklet
Back Stop Failure RAP. If the stack hold solenoids are operating correctly, check carefully for
any contamination or debris in the compiling area of the BM, that could cause the mis-align-
ment.
Badly Formed Booklet Staples
If the booklet staples are not formed correctly, perform ADJ 11.3-170 Staple Anvil Alignment.
Booklet Compiler is Not Correct
If the page order of the booklets is not correct, perform ADJ 11.6-170 Booklet Compiling Posi-
tion.
August 2007
2-532
95% of booklets 99.7% of booklets
1mm 2mm
2mm 3mm
WorkCentre 5687 Family