Xerox WorkCentre 5687 Series Service Manual page 1526

REP 11.50-171 BM Eject Sensor
Parts List on PL 11.88
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the BM right hand cover, REP 11.56-171.
2. Remove the upper exit brush (3 screws), PL 11.88 Item 16.
3. Figure 1, remove the BM eject sensor.
Figure 1 Sensor removal
Replacement
Reverse the removal procedure to replace the BM eject sensor.
Repairs/Adjustments
REP 11.50-171, REP 11.51-171
2
Disconnect
the harness
and remove
the sensor
1
Remove the
screw then slide
out the sensor
August 2007
4-506
REP 11.51-171 Compiler Paper Pusher Motor Assembly
Parts List on PL 11.145
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the top and rear covers REP 11.1-171.
2. Remove the paper pusher motor assembly, Figure 1.
Figure 1 Paper Pusher Motor Assembly
Replacement
Reverse the removal procedures to reinstall the compiler paper pusher motor assembly.
Motor bracket rear screw
Motor bracket front screws
Disconnect the Motor PJ
WorkCentre 5687 Family