Xerox WorkCentre 5687 Series Service Manual page 1381

REP 11.26-170 Back Stop Drive Assembly
Parts List on PL 11.82
Purpose
This procedure is used to repair the following components:
• BM back stop link springs, PL 11.82 Item 15.
• BM back stop link, PL 11.82 Item 16.
• BM back stop idler shaft, PL 11.82 Item 13.
• BM back stop drive belt, PL 11.82 Item 7.
• BM back stop bearing, PL 11.82 Item 11.
• BM back stop idler bracket, PL 11.82 Item 12.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the HCSS BM front door and fully pull out the BM module.
2. Remove the crease blade knob (6d), PL 11.80 Item 4.
3. Remove the crease roll handle (6c), PL 11.80 Item 5.
4. Remove the BM front cover, PL 11.80 Item 3.
5. Remove the LH frame plate, PL 11.82 Item 16.
6. Remove the BM tamper assembly, REP 11.30-170.
7. Remove the backstop motor assembly, REP 11.20-170.
8. Remove the backstop assembly, REP 11.21-170.
9. Remove the crease blade assembly, REP 11.36-170.
10. Figure 1, remove the BM backstop drive shaft and bearings.
WorkCentre 5687 Family
3 4
Remove KL-clip Remove the
drive shaft
and bearing
Figure 1 Drive shaft removal
11. Figure 2, remove the backstop link.
August 2007
4-361
2
Remove KL-clip
and pulley
1
Remove E-clip
and bearing
Repairs/Adjustments
REP 11.26-170