Xerox WorkCentre 5687 Series Service Manual page 1163

REP 8.28 Tray 3 Feed Sensor
Parts List on PL 8.30
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Pull out Tray 3.
2. Remove the network controller, PL 16.10.
3. Remove the rear cover, PL 7.25 Item 1.
4. Remove tray 3 feed sensor, Figure 1.
1
Disconnect the harness
Figure 1 Tray 3 feed sensor
Replacement
Replacement is the reverse of the removal procedure.
WorkCentre 5687 Family
REP 8.29 Tray 3 Takeaway Roll Assembly
Parts List on PL 8.35
Removal
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove tray 3 transport assembly, REP 8.13.
2. Remove the jam clearance door, Figure 1.
2
Press the tabs together
to release the sensor
August 2007
4-143
WARNING
WARNING
Repairs/Adjustments
REP 8.28, REP 8.29