Xerox WorkCentre 5687 Series Service Manual page 1499

13. Figure 5, remove the BM stapler bracket assembly.
Figure 5 Assembly removal
Replacement
Reverse the removal procedure to replace the BM stapler bracket assembly and components.
WorkCentre 5687 Family
REP 11.29-171 BM Conveyor Belts
Parts List on PL 11.169
Removal
1
Lever out
Take care during this procedure. Sharp edges may be present that can cause injury.
the bearing
using a
screwdriver
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
NOTE: The removal procedure illustrates how to remove the rear conveyor belt. The proce-
dure for the front conveyor belt is similar.
1. Remove bin 2 by disconnecting the harness, removing the thumb screw then lifting the bin
upwards to release.
2. Remove the BM bin 2 extension by aligning the pivot pins with the cutouts and snapping
the extension out of engagement.
3. Turn over bin 2 and remove the base pan, 3 screws.
4. Remove the BM bin 2 connector from the base pan, 1 screw.
2
Remove the
bracket
assembly
from the front
August 2007
4-479
WARNING
WARNING
Repairs/Adjustments
REP 11.28-171, REP 11.29-171