Xerox WorkCentre 5687 Series Service Manual page 1254

5
Remove 1 screw from the belt clamp.
Remove the belt.
Figure 2 Bin 1 drive belt removal (rear)
7. Remove the bin 1 drive belt (front) Figure 3.
Repairs/Adjustments
REP 11.5-120
4
Remove 2 screws then
the upper pulley.
Standoff.
3
Disconnect PJ.
2
Remove 3 screws
marked A. Release 1
standoff.
1
Remove 2 screws then the lower pulley.
Figure 3 Bin 1 drive belt (front)
Replacement
NOTE: Ensure the correct set of components are used for each side of the 1K LCSS.
1. Reverse the removal procedure to replace the bin 1 drive belts.
NOTE: Bin 1 level can critically affect the overall stack registration. Refer to ADJ 11.1-120
if adjustment is necessary.
August 2007
4-234
3
Remove two screws
then the upper pul-
ley.
4
Remove screw and front
belt clamp. Remove the
belt.
1
Release the tensioner
spring.
2
Remove two screws then
the lower pulley.
WorkCentre 5687 Family