Xerox WorkCentre 5687 Series Service Manual page 1303

2
Push shaft to the rear to release the belts
3
4
Slide belts off the
Rest the belts on
upper pulley
top of the frame
Figure 2 Release belts
5. Figure 3, remove the bracket.
WorkCentre 5687 Family
1
Remove E-clip and
bearing at each end
of the shaft
5
Remove the upper
pre-compile pulley
August 2007
4-283
Figure 3 bracket removal
6. Figure 4, remove the vertical transport belts.
3
Remove the bracket
1
Use a hex driver to
remove 2 screws
2
Use a ratchet
wrench and 5.5mm
socket to remove 2
screws
Repairs/Adjustments
REP 11.14-130