Xerox WorkCentre 5687 Series Service Manual page 1091

REP 5.13 Exit Roll Assembly
Parts List on PL 5.35
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the feed assembly, REP 5.3.
2. Remove the input tray assembly, REP 5.4.
CAUTION
(32-38 ppm) Disconnect the ground harness from the static eliminator before the input tray
assembly lower cover is removed, refer to Figure 1.
3. Turn the input tray assembly upside down. Remove the relevant cover:
• (32-38 ppm) Input tray assembly lower cover, PL 5.35 Item 21.
• (45-87 ppm) Lower cover (right), PL 5.35 Item 9 and Lower cover (left), PL 5.35 Item
20
4. Remove the exit roll assembly, Figure 1.
Figure 1 Exit roll assembly
WorkCentre 5687 Family
Replacement
Take care when installing self tapping screws into plastic components, refer to GP 6.
The replacement is the reverse of the removal procedure. Make sure the spacers and E-clips
are installed correctly, refer to Figure 1.
Black spacers.
E-clip.
Ground harness.
See CAUTION.
1
Remove the exit roll
assembly.
August 2007
4-71
CAUTION
Repairs/Adjustments
REP 5.13