1
Remove 4 screws and 2
ground wires.
2
Disconnect PJ565 from the BM flapper roll
motor and PJ 587 from the BM flapper roll
home sensor.
3
Remove the BM flapper assembly.
Figure 1 Remove the BM flapper assembly
3.
Figure 2, remove the BM flapper.
WorkCentre 5687 Family
1
Remove the E-clip and the
bearing.
Figure 2 BM flapper removal
4.
Figure 3, remove the BM flapper roll motor and the BM flapper roll home sensor.
2
Remove 2 screws and
the ground harness.
Figure 3 BM flapper removal
Replacement
The replacement is the reverse of the removal procedure.
August 2007
4-347
3
Remove the BM flapper.
2
Remove the
E-clip and the
bearing.
1
Release the BM flapper
roll home sensor.
3
Remove the BM flapper roll motor.
Remove the worm gear.
Repairs/Adjustments
REP 11.16-170