Table of Contents
Advertisement
REP 14.11A Scan Motor (32-55 ppm)
Parts List on PL 14.25
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord. Electricity
can cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
1.
Remove the CVT glass and document glass, REP 14.6A.
2.
Mark the position of the scan motor bracket, Figure 1.
Scribe a line
Figure 1 Motor bracket position
3.
Remove the scan motor and remove the weight (32-38 ppm only), Figure 2.
WorkCentre 5687 Family
4
3
Loosen 2 grub screws and remove
Remove the motor
the flywheel
and bracket
2
Remove 2 screws
Replacement
1.
Re-assemble the motor onto the bracket and fully tighten the screws.
2.
Replace motor / bracket assembly into the optics cavity, engage the motor pulley with the
drive belt and install the two screws, but do not tighten.
3.
Move the motor / bracket assembly to the right until the bracket aligns with the scribe line,
Figure 1, then fully tighten the screws.
4.
Re-install the flywheel and tighten the 2 screws.
5.
Re-install the CVT glass and document glass.
6.
Ensure that the weight (32-38 ppm only) is fitted onto the new motor.
August 2007
4-573
Weight (32-38
ppm only)
5
Remove 2 screws and remove
the motor from the bracket
1
Disconnect PJ456
Figure 2 Motor removal
Repairs/Adjustments
REP 14.11A
Hide quick links:
Advertisement
Chapters
Table of Contents
