Xerox WorkCentre 5687 Series Service Manual page 1358

REP 11.10-170 Chad Bin Level Sensor, Actuator and
Spring
Parts List on PL 11.66
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the chad bin.
2. Separate the HCSS BM from the machine, REP 11.13-170.
3. Remove the HCSS BM top cover, rear cover, upper left cover, front door and front infill
cover, REP 11.1-170.
4. Remove the front left cover, PL 11.60 Item 3.
5. Figure 1, remove the cover.
2
Gently bend the cover to
release the dowels
Figure 1 Cover removal
Repairs/Adjustments
REP 11.10-170
6. Figure 2, remove the screws securing the docking bracket and the chad bin support.
Remove 8 screws.
1
Remove two
screws
August 2007
4-338
Figure 2 Preparation for bracket removal
WorkCentre 5687 Family