Table of Contents
Advertisement
2.
Pull out the hole punch assembly a short distance to access the spacer, if installed, refer
to Figure 2. The following settings can be made:
NOTE: If the spacer cannot be found, suitable washers up to a total thickness of 2mm
(0.080 inches) may be used.
•
With no spacer installed the holes are punched closest to the bottom of the sheet.
•
With the spacer installed unfolded the holes are punched 1mm (0.40 inches) closer
to the top of the sheet.
•
With the spacer installed folded the holes are punched is 2mm (0.080 inches) closer
to the top of the sheet.
Spacer unfolded to give
Spacer folded to give 2mm
(0.080 inches) offset
1mm (0.040 inches) offset
towards the top
towards the top
Figure 2 Hole punch spacer
3.
Evaluate the movement needed and re-position the hole punch assembly. If the spacer is
removed, tape it next to the TAG label on the HCSS BM frame for future use.
4.
Make sets from each of the indicated trays once more and ensure that the hole alignment
is now optimized, make further adjustment if necessary.
5.
If necessary, re-load the paper trays as they were before the adjustment was performed.
Repairs/Adjustments
ADJ 11.2-170, ADJ 11.3-170
ADJ 11.3-170 Stapler Anvil Alignment
Parts List on PL 11.88
Purpose
To ensure the correct alignment of the stapler anvil to the stapler throat.
Special Tools Required
Stapler alignment tool, supplied with the HCSS BM, located on the left of the BM frame.
NOTE: This procedure illustrates the front stapler. The procedure for adjusting the rear stapler
is identical.
Adjustment
Switch off the electricity to the machine GP 14. disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1.
To improve the access to the two clamp screws for the anvil, remove the tamper assem-
bly, REP 11.30-170.
2.
Fully pull out the BM module. Remove the stapler cover(s), one screw on each. Pull the
stapler bracket handle and swing open the stapler bracket.
3.
Figure 1, insert the alignment tool.
August 2007
4-654
WARNING
WARNING
WorkCentre 5687 Family
Hide quick links:
Advertisement
Chapters
Table of Contents
