Xerox WorkCentre 5687 Series Service Manual page 1572

Replacement
Reverse the removal procedures to replace the left hand cover interlock switch.
When reinstalling the inside top cover and the top cover make sure that the correct screws are
used and that the screws are not overtightened GP 6
Repairs/Adjustments
REP 11.88-171, REP 11.89-171
REP 11.89-171 Main Tray and Paper Length Sensors
Parts List on PL 11.175
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Pull the lug on one side of the tray to disconnect from the frame pivot. Remove the cover
plate then disconnect the PJs and remove the sensors from the bracket clips, Figure 1
Frame Pivot
Figure 1 Main Tray Assembly
Replacement
Reverse the removal procedures to replace the PPI main tray and paper length sensors.
August 2007
4-552
WARNING
WARNING
Paper Length
Sensors
Cover Plate
WorkCentre 5687 Family