Xerox WorkCentre 5687 Series Service Manual page 1531

c. Figure 7, Ensure that the tabs of the outer gear keyed clutch plate are not outside of
the grooves in the gear.
Figure 7 Outer gear keyed clutch plate
d. Figure 8, ensure that the final shaft keyed clutch plate does not come off of the shaft
during installation.
Figure 8 Outer gear keyed clutch plate
WorkCentre 5687 Family
e.
f.
3. Install the remainder of the removed components by reversing the removal procedure.
Outer gear keyed
clutch plate
Tabs
Grooves
Final shaft keyed
clutch plate
August 2007
4-511
Tighten the screw on the front end of the shaft until it reaches a hard stop.
Check that the lower crease roll gear and clutch assembly is secure on the shaft. If
necessary, repeat steps A to D.
Repairs/Adjustments
REP 11.52-171