Table of Contents
Advertisement
REP 11.15-130 Vertical Transport Nip Rollers
Parts List on PL 11.40
Removal
NOTE: The vertical transport contains eight identical nip rollers, the repair procedure is identi-
cal for all.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1.
Open the HCSS front door.
2.
Figure 1, Remove a vertical transport nip roller.
2
Slide the nip roller
assembly partially out
Figure 1 Roller removal
Replacement
Reverse the removal procedures to replace the vertical transport nip rollers.
WorkCentre 5687 Family
1
Pinch the
legs together
3
Hold the spring
and remove
together with
the nip roller
assembly
REP 11.16-130 Chad Full Bin Sensor, Actuator and Spring
Parts List on PL 11.36
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1.
Remove the chad bin.
2.
Separate the HCSS from the machine, REP 11.19-130.
3.
Remove the HCSS top cover, rear cover, upper left cover, front door and front cover, REP
11.1-130
4.
Figure 1, remove the cover.
1
Remove two screws
5.
Figure 2, remove the screws securing the docking bracket and the chad bin support.
August 2007
4-285
WARNING
WARNING
2
Gently bend the cover to release the dowels
Figure 1 Cover removal
Repairs/Adjustments
REP 11.15-130, REP 11.16-130
Hide quick links:
Advertisement
Chapters
Table of Contents
