Xerox WorkCentre 5687 Series Service Manual page 1532

REP 11.53-171 Compiler Paper Pusher
Parts List on PL 11.145
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the front, rear and top covers REP 11.1-171.
2. Remove the stacker motor gearbox, REP 11.12-171.
3. Remove the stacker shaft front bearing bracket and the exit guide plate front and rear
screws, Figure 1.
Figure 1 Stacker Shaft Front Bearing Bracket
4. Remove the pusher driving motor assembly, REP 11.51-171.
5. Remove the pusher sensor assembly, REP 11.54-171.
Repairs/Adjustments
REP 11.53-171
6. Remove the front and rear screws and push the left edge of the compiler exit guide plate
downward away from the pinion shaft, Figure 2.
Exit Guide Plate
7. Remove the pinion shaft front and rear circlips, the shaft bearings and the front bearing
Stacker front bearing
thrust washers then remove the pinion shaft, Figure 2.
bracket
8. Lift the pusher module out of the guides. The mylar strips and dampers are attached to
the pusher module, Figure 2.
Replacement
Reverse the removal procedures to reinstall the compiler paper pusher.
August 2007
4-512
Figure 2 Pusher Guide and Pinion Shaft
WorkCentre 5687 Family
Pinion Shaft
Pusher Module