Xerox WorkCentre 5687 Series Service Manual page 726

If the booklet crease position does not conform to the specification in Table 5, perform ADJ
11.7-170 Booklet Crease Position.
Booklet Staple Position is Not On The Fold
Figure 5, open out the booklet at the centre page and press it onto a flat surface. Measure the
position of the booklet staple from the crease line.
Figure 5 Booklet staple position
If the booklet staple position does not conform to the specification in Figure 5, perform ADJ
11.8-170 Booklet Staple Position.
The Booklet is Not Sufficiently Creased
Figure 6, Measure the open dimension of the booklets.
Status Indicator RAPs
11F-170
Staple position
must align with the
crease +/-1.5mm
August 2007
2-534
Figure 6 Booklet creasing
Table 6 Creasing tolerance
Paper size A4,
8.5x11in, Paper size A4,
8.5x13in or 8.5x11in, 8.5x13in
Paper weight 8.5x14in or 8.5x14in
- 95% of booklets 99.7% of booklets 95% of booklets 99.7% of booklets
80gsm (20lb) Less than 30mm Less than 35mm
If the open dimension of the booklets does not conform to the specification in Table 6, install
new crease nip springs, PL 11.84 Item 12.
Paper size A3 or Paper size A3 or
11x17in 11x17in
Less than 22mm Less than 25mm
WorkCentre 5687 Family