Xerox WorkCentre 5687 Series Service Manual page 844

Skewed Booklet Crease
Figure 3, open out the booklet at the centre page and press it onto a flat surface. Measure the
amount of booklet skew.
Figure 3 Booklet skew
Table 4 Skew tolerance
Paper size A4, Paper size A4,
8.5x11in, 8.5x11in,
8.5x13in or 8.5x13in or
Paper weight 8.5x14in 8.5x14in
95% of 99.7% of
- booklets booklets
80gsm (20lb) Less than Less than 2.5mm Less than
1.0mm
All other booklet Less than Less than 3.0mm Less than
maker approved 1.5mm
weights in GP 20
Status Indicator RAPs
11D-171
The amount of skew is the difference
between the two measurements
Paper size A3 Paper size A3
or 11x17in or 11x17in
95% of 99.7% of
booklets booklets
Less than
1.4mm 3.1mm
Less than
2.1mm 3.6mm
If the booklet skew does not conform to the specification in Table 4, check the operation of the
BM stack hold solenoids, refer to the 11-065-171, 11-383-171 HVF Booklet Back Stop Failure
RAP. If the stack hold solenoids are operating correctly, check for any contamination or debris
in the compiling area of the BM, that could cause the mis-alignment.
Booklet Crease is Off Centre
Figure 4, open out the booklet at the centre page and press it onto a flat surface. Measure the
position of the booklet crease.
Measure from the booklet
edge to the crease
Figure 4 Booklet crease position
Table 5 Crease position and tolerance
Paper size Edge to crease measurement
A4 148.5 +/- 1.5mm
A3 210 +/- 1.5mm
8.5x11 inch 139.5 +/- 1.5mm
8.5x13 inch 165.1 +/- 1.5mm
8.5x14 inch 178.0 +/- 1.5mm
11x17 inch 216.0 +/- 1.5mm
August 2007
2-652 WorkCentre 5687 Family