Xerox WorkCentre 5687 Series Service Manual page 1481

8. Figure 2, remove the BM crease blade motor.
3
Remove the sensor
from the bracket
Figure 2 Removing the motor
WorkCentre 5687 Family
Replacement
Reverse the removal procedure to replace the BM crease blade motor.
NOTE: Ensure that the mark on the crease blade knob aligns with the arrow on the front infill
cover when the crease blade is fully withdrawn.
1
Support the encoder
and slide out the shaft
2
Remove the encoder
August 2007
4-461
Repairs/Adjustments
REP 11.18-171