Xerox WorkCentre 5687 Series Service Manual page 1221

REP 10.17 IOT Exit Sensor
Parts List on PL 10.11
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present can cause injury.
1. Remove the output device.
2. Remove the right hand cover, PL 8.10 Item 9.
3. Remove the tie bar, Figure 1.
1
Remove 4 screws
2
Disconnect the harness from the
inverter motor driver PWB
Figure 1 Remove the tie bar
4. Release the nip roll guide, Figure 2.
WorkCentre 5687 Family
5. Remove the IOT exit sensor, Figure 3.
3
Remove the tie bar
August 2007
4-201
1
Remove two screws
Figure 2 Release the nip roll guide
2
Lift the guide to release
the nip roll guide
Repairs/Adjustments
REP 10.17