Table of Contents
Advertisement
ADJ 11.6-171 Booklet Compiling Position
Purpose
To set the compiling position to ensure correct compiling without damage. When the compiling
position is correctly set, each sheet is fed behind the BM entry roll to rest against the right side
of the compiler.
Procedure
Go to the appropriate check and adjustment from the following options:
•
If only A4 paper is available, go to A4 Paper Procedure.
•
If only 8.5 X 11 inch paper is available, go to 8.5 X 11 Inch Procedure.
A4 Paper Procedure
Check
1.
Open the HVF BM front door and insert an interlock cheater into the front door interlock
switch.
2.
Fully pull out the BM module and release the jam clearance handle PL 11.161 Item 8, fully
open the paper guide PL 11.161 Item 7.
3.
Enter dC330 code 11-065 BM Backstop Motor, select Start, allow the backstop to raise to
the receive position (where it will pause), select Stop.
4.
Insert a single sheet of A4 paper short edge downward into the booklet maker compiling
area, so that it rests on the backstop and is approximately central front to back. Tuck the
top of the sheet behind the BM entry roll, PL 11.161 Item 5.
5.
If the BM right hand cover does not have a viewing hole, remove the BM right hand cover,
REP 11.56-171.
6.
Figure 1, check the alignment of the sheet against the scale.
Repairs/Adjustments
ADJ 11.6-171
Top of sheet must align
with the 0 mark on the
B scale
Figure 1 Top edge alignment
7.
If the sheet is correctly aligned, exit diagnostics and re-install the BM right hand cover, if
removed in step 5. If the sheet is not correctly aligned, perform the adjustment.
August 2007
4-680
WorkCentre 5687 Family
Hide quick links:
Advertisement
Chapters
Table of Contents
